|
Replacing the battery on a Blackout Buster B6U |
|
|
Written by Administrator
|
|
Saturday, 03 January 2009 |
|
Page 2 of 3 Step 4. This step we are going to take off the screws on the side of the UPS. I have mark the areas with RED arrows so you can see which screws to take off. Please lay down the UPS so the Front side of the UPS is on your left and the back end is towards your right. Here goes the pictures of the UPS and where there is a RED ARROW is the screws you will need to take off.  Step 5. You will need to pull down the gray feet of the UPS so you can get to the other screws. The UPS should be laying down flat on top of the table. Put your fingers on the Gray feet of the UPS and pull downwards. Once you have them off, it should look like this picture. Step 6. You will need to take off the screws from the UPS. They are mark with the Red arrow. Step 7. We are now going to take off the screws from the back side of the UPS, where all the outlets plug in. They are fours screws that will need to be taken off and they are mark in RED arrows. 
You have two screws on top 
And two screws in the bottom of the UPS So start taking off the screws |
|
Last Updated ( Tuesday, 06 January 2009 )
|
